Cleaning Of Tapered bit

Comments · 64 Views

Tapered Bit's hydraulic parts should be disassembled and cleaned in a clean room that meets national standards.

  1. Tapered Bit's hydraulic parts should be disassembled and cleaned in a clean room that meets national standards. It is recommended that the operating room be filled with pressure if conditions permit, so that the indoor pressure is higher than the outdoor pressure to prevent atmospheric dust pollution. If restricted by conditions, the operation room should also be isolated separately. Generally, the hydraulic parts assembly room and the machining room or fitter's room are not allowed to be in the same room. It is absolutely forbidden to disassemble and assemble hydraulic parts in the open air, shed, utility room or warehouse. When disassembling hydraulic parts, the operator should wear work clothes and work caps that are not easy to fall out of fibers to prevent fibers, dust, hair, dander, etc. from falling into the hydraulic system and causing artificial pollution. Smoking and eating in the operation room are strictly prohibited.
      2. The cleaning of hydraulic parts should be carried out on a special cleaning table. If restricted by conditions, the cleanliness of the temporary work table should also be ensured.
      3, Drill pipe cleaning fluid allows the use of kerosene, gasoline and hydraulic oil with the same grade as the working oil of the hydraulic system.
      4. The cleaned parts are not allowed to be wiped with cotton, linen, silk and chemical fiber fabrics to prevent the fallen fibers from polluting the system. If necessary, clean and dry compressed air can be used to dry the components.
Comments