Auto Parts Factory Introduces The Knowledge Of Maintaining Auto Parts

Comentários · 242 Visualizações

Auto parts processing is the unit that constitutes the whole of auto parts processing and the products that serve the processing of auto parts.

 

Auto parts processing is the unit that constitutes the whole of auto parts processing and the products that serve the processing of auto parts. Next, Auto Parts Factory  will introduce the method of maintaining auto parts:

1. The engine piston temperature is too high, it is easy to cause overheating and melting and hold the cylinder.

2. Overheating of rubber seals, triangular tapes, tires, etc., is prone to premature aging, performance degradation, and shortened service life.

3. The coils of starters, generators, regulators and other electrical equipment are overheated, and they are easily burned and scrapped. The engine cylinder head gasket should not be installed backward, otherwise, it will cause premature ablation and damage to the head gasket.

4. When installing the engine fan blades, do not reverse it; for tires with directional patterns and chevron pattern tires, the ground impression after installation should make the chevron tip point to the rear.

Through the above introduction,Motorcycle Parts Factory hopes that you can simply refer to the content of this article in future use.

 

Comentários