Use Of Rock Button Bits

Comments · 217 Views

Rock Button Bits can work effectively with various muds, including oil-based mud, emulsified mud and clay mud, and even clean water.

      Requirements

  1. Drilling fluid requirements: Rock Button Bits can work effectively with various muds, including oil-based mud, emulsified mud and clay mud, and even clean water. The mud viscosity and specific gravity have little effect on the drilling tool, but it has a direct impact on the pressure of the entire system. If the pressure under the recommended displacement is greater than the rated pump pressure, the mud displacement must be reduced, or it is necessary to reduce the flow through the drilling tool and The pressure drop of the drill bit. Impurities such as sand particles in the mud will affect the performance of the drilling tool and accelerate the wear of the bearing and motor stator. Therefore, the sand content in the mud must be controlled below 1%. Each type of drilling tool has its own input flow range, and only within this range can the drilling tool have higher efficiency. Generally, the middle value of the input flow range should be taken as the better input flow value.

 

  1. Mud pressure requirements: When the Water Well Drilling Tools is suspended, the displacement remains the same, and the mud pressure drop through the drilling tool is also unchanged. As the drill bit contacts the bottom hole and the WOB increases, the mud circulation pressure increases, and the pump pressure also increases. , The driller can use the following formula to control the operation: Drilling pump pressure = circulating pump pressure + drilling tool load pressure drop The circulating pump pressure is the pump pressure when the drilling tool does not touch the bottom of the well, also called the off-bottom pump pressure, and the drilling tool increases the torque , The pump pressure is about to rise, at this time the reading of the pressure gauge is called the drilling pump pressure. The off-bottom pump pressure is not a constant, it varies with the well depth and the characteristics of the mud, but in actual operation, it is not necessary to measure the accuracy of the circulating pump pressure at any time. Generally, the off-bottom pump pressure after each connection is taken as Approximate value, this can fully meet the accuracy requirements of the formula. When the drilling tool is working, when the drilling pump pressure reaches a higher recommended pressure, the drilling tool will produce better torque. Continue to increase the drilling pressure will increase the pump pressure. When the greater design pressure is exceeded, the motor may brake, and you should Lower the WOB to prevent internal damage to the drilling tool.
Comments